Symmetricom Time Server Manuel d'utilisateur télécharger pdf (Page 49)

6000-100Ch3.fm Rev. D TimeVault™ User’s Manual 3-35

Web Access Chapter 3: Remote Operation

where:

number = the ACTS telephone number, including area code;

this example shows the NIST service in Boulder,

CO, U.S.A.

line = access digit for an outside dial tone

inter = prefix for international and long distance service (up

to 9-digits)

type = tone or pulse dialing

retry = number of times the modem tries to reach ACTS

timeout = after sending a command to the modem, the time

interval, in seconds, that TimeVault waits for a

modem response before timing out

duration = duration, in seconds, of a single ACTS session,

starting after the modem detects a carrier

delay = reserved for factory calibration only; do not change

period = time interval, in minutes, between call attempts

flag = set to ON by default; do not change

speed = baud rate, set to 9600 by default; reserved for

factory calibration only; do not change

fudge = reserved for factory calibration only; do not change

pollcounter = determines time precision vs. risk of unsuccessful

call; reserved for factory calibration only; do not

change

center = calibration of the phone line; reserved for factory

calibration only; do not change

modemInit = modem initialization string; reserved for factory

calibration only; do not change

3. Edit the file.

4. Press

<Enter> or click Submit Changes just below the display of parameter values.

TimeVault takes a moment to reset, during which time the parameter display goes

blank. When TimeVault starts up again, the new parameters are in place. If the unit

does not reset, check the status message to see why, re-enter the values, then click

Submit Changes again.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 147 148

Pas de commentaire

Symmetricom Time Server Manuel d'utilisateur Page 49